Range Rover (LP) V8-4.0L (1999)
^
If installed, remove grommet from the affected door (Figure 6 and Figure 7) for access to the door lock tensioning screw.
NOTE:
The door lock tensioner screws rotate counterclockwise on LH doors, clockwise on RH doors to release tension.
^
Release the door lock tensioning screw two turns.
^
Tighten the door lock tensioning screws to 4 Nm (3 lbf ft).
4.
Install the door lock tensioning screw grommet.
5.
Close front and rear doors.
Disclaimer
Technical Service Bulletin # TEC7615032
Date: 040604
Body - Lock/Latch Systems Diagnosis/Repair
No: 76/15/03/NAS
Ref:
* Issue: 2
Date: June 04, 2004 *
Troubleshooting Problems with Handles, Locks and Latches
AFFECTED VEHICLE RANGE:
Range Rover (LM) All
Updated information is shown with asterisks.
SITUATION:
CUSTOMER DIFFICULTIES WITH LOCKING/LATCHING SYSTEM
The customer may experience difficulties with the locking system and latch mechanisms. A range of situations can contribute to these situations. To
avoid the need to change side door latches unnecessarily it is necessary to identifying the root causes.
RESOLUTION:
INVESTIGATE AND DETERMINE ROOT CAUSE OF PROBLEM