Range Rover (LP) V8-4.0L (1999)
9. Using a 'U' shaped blade, cut through adhesive bead along upper and lower edges of glass.
CAUTION: Access around lower clips is restricted. maneuver blade to cut through as much adhesive as possible.
10. Attach suction lifters to glass. With assistance, cut through remaining sealant around lower clips.
11. With assistance, remove backlight glass.
Removal Using Cutting Wire Handles
12. Using a sharp knife, cut through P.U. sealer at side of backlight.
13. Insert cutting wire through knife cut and fit handles, as shown, with approximately 200mm of wire between handles.
14. With assistance, wedge tube of handle 'A' between glass and body, ahead of the cutting position, and carefully cut the sealer using a continuous
pull on handle 'B' from the outside. Cut side and top edges first. Attach suction lifters and restrain glass as last of sealant is cut.
NOTE: When cutting along lower edge, maneuver wire between glass edge and finisher clips to reduce strain on wire.