Range Rover (LP) V8-4.0L (1999)
/v8-4.0l/Page-450002.png)
6. Progressively slacken and remove 4 bolts securing rocker shaft assembly to cylinder head.
7. Remove rocker shaft assembly.
8. Remove pushrods and store in installed order.
Installation
Rocker Arm Assembly - Installation
1. Lubricate pushrods with engine oil.
2. Install pushrods in removed order.
3. Install each rocker shaft assembly, ensuring identification groove is uppermost and towards front of engine on RH side and towards 'rear of engine
on LH side.
CAUTION: Incorrect installation of rocker shafts will lead to an oil feed restriction.
