Range Rover (LP) V8-4.0L (1999)
The harness retainer will be used for reassembly.
8.
Remove latch assembly as follows:
^
Unscrew and remove sill button from linkage.
^
Remove three latch screws.
^
Detach interior release cable from latch.
^
Remove latch from vehicle.
MODIFICATIONS
1.
Drill two 7 mm (17/64 in.) holes in door casing as shown in Figure 3. Touch up exposed metal using Dinotrol(R) AV25 (RTC7769125).
Update two-cavity connector housing.
^
Remove wire terminal from the existing connector housing by releasing the terminal as shown in Figure 4 and discard old housing.