Range Rover (LP) V8-4.0L (1999)
Fuel Filler Neck: Service and Repair
Service repair no - 19.55.07
Remove
WARNING: Ensure that fuel handling precautions given in 01 - Introduction are strictly adhered to when carrying out following
instructions.
WARNING: If the fuel tank is full, the fuel level may be close to the filler neck aperture. If gauge indicates over 75%, drain a minimum
of 10 liters (2.6 US Gallons) from fuel tank. See: Service and Repair
CAUTION: Before disconnecting any part of the system, it is imperative that all dust, dirt and debris is removed from around
components to prevent ingress of foreign matter into fuel system.
Remove
1. Open fuel filler flap and remove filler cap.
2. Disconnect battery earth lead.
3. Remove RH rear wheel arch liner. See CHASSIS AND BODY, Repair.
4. Remove nut securing filler neck bracket to stud.
5. Disconnect vent line quick fit connectors at fuel/vapor separator and under body connection.
6. Disconnect pressure sensor breather pipe connection.
7. Remove shear cap from clip securing neck assembly to tank.
8. Slacken clip securing neck assembly to tank.
9. Release filler neck bracket from body stud. Push filler neck down then forwards to release from aperture grommet.
10. Remove tiller neck assembly.