Range Rover (LP) V8-4.0L (1999)
/v8-4.0l/Page-1400001.png)
Power Steering Bleeding: Service and Repair
1. Fill reservoir to upper mark on dipstick.
2. Turn steering wheel 45° in both directions to open valves inside steering box.
3. Top up steering reservoir fluid level.
CAUTION: Do not run engine with less than minimum fluid level in reservoir. Top up as necessary during bleed procedure.
4. Start engine. Allow to idle.
5. Turn steering wheel back and forth to open valves inside steering box.
WARNING: Fluid is under high pressure, open bleed screw with caution.
6. With engine running, carefully open bleed screw until fluid starts to flow. Tighten bleed screw to 4 Nm (3 ft. lbs.)
7. Switch off engine. Top up reservoir.
