Range Rover (LP) V8-4.0L (1999)
/v8-4.0l/Page-1402002.png)
3.
Clean the area around the PAS fluid reservoir cap and remove the reservoir cap.
NOTE:
GTR lookup sequence is as follows: GTR Home > NAS > Service Information/LM Range Rover/2004 > Workshop Manuals > Service
Procedures > "EXTERIOR FITTINGS/REPAIRS > "Undertray - front" link.
4.
Refer to GTR Section 76.11.81 and remove the engine undertray.
5.
Position a suitable container to collect PAS fluid spillage under the vehicle.
CAUTION:
Before disconnecting PAS joints, ensure the immediate area around the joint is clean to prevent contamination.
6.
Disconnect the PAS supply hose as follows:
^
Note the orientation of the PAS fluid supply hose to Figure the PAS pump. (Figure 1)
^
Loosen the union nut.
^
Disconnect the hose.
^
If undamaged, retain the 0-ring seal for refill-flush-drain procedure.
^
Allow the PAS fluid to drain from the system.
CAUTION:
The front wheels must not be freely suspended during the purge process.
7.
With the vehicle placed on the swivel plates and Supply without engine running, cycle the steering ten times through full left steering lock to full
right steering lock to ensure maximum quantity of fluid is purged from the system.
NOTE:
Ensure a new 0-ring seal is installed to the PAS pump hose prior to final assembly.
8.
Clean the residual fluid from the PAS pump and reconnect the supply hose in its original orientation with washer.
9.
Fill the PAS reservoir with new PAS fluid (LRN2261).
10.
Start the engine and allow to idle for two minutes while slowly cycling the steering lock to lock.
NOTE:
GTR lookup sequence is as follows: GTR Home > NAS > Service Information/LM Range Rover/2004 > Workshop Manuals > Service
Procedures > "STEERING/ADJUSTMENTS" > "Power assisted steering (PAS) system - bleed" link.
11.
Refer to GTR section 57.12.02 and add PAS fluid to the PAS reservoir when necessary as air is purged from the system.
12.
Switch engine off.
13.
Repeat drain procedure from step 6, before proceeding to step 14.
