Range Rover (LP) V8-4.0L (1999)
Power Steering Pump: All Technical Service Bulletins
Recall - Power Assist Steering (PAS) Pump Replacement
No:
D385
Ref:
Issue:
1
Date:
10/15/99
RECALL
PAS Pump Pulley Improvements
AFFECTED VEHICLE RANGE:
Range Rover (LP)
XA400940 to XA427315
Vehicles with Bosch Engine Management only
SITUATION:
PAS PUMP PULLEY FAILURE
The loading condition present on the Range Rover power assist pump pulley can cause the joint between the pulley and its center hub to fail. In the event
of a pulley failure, the serpentine drive belt will also be subjected to damage resulting in loss of engine auxiliary functions (power assisted steering,
electrical charging system and vehicle cooling). Should the serpentine belt fail, the alternator warning light will illuminate on the instrument panel, the
message center will indicate "Alternator Fault" and an audible alarm (beep) will sound.
RESOLUTION:
REPLACE PAS PUMP/PULLEY ASSEMBLY
All Range Rover vehicles within the specified VIN range require replacement of the PAS pump/pulley assembly.
All affected vehicles currently held in retailer inventory as new or used vehicles must be repaired prior to sale.
PARTS INFORMATION:
CAUTION:
Retailer inventory of PAS pump QVB101300 may NOT be used to repair a vehicle. Return QVB101300 pumps to Land Rover using a PAF
referencing this bulletin.
LRN0002LABEL
Campaign label
Qty 1
QVB000040K
PAS Pump
Qty 1
ANR2377
PAS hose clip
Qty 1
LRNA241C
PAS hose clip
Alternate
Locally Source:
Power Steering Fluid
Quantity as required - 1 pint allowed for
TOOLS
LRA-99-001
Standard Jaw Pinchers (Model 1089)
Locally sourced
Vernier Calipers
WARRANTY CLAIMS:
D385 Option 1
0.15 hrs
Inspect PAS Pump pulley and install label
D385 Option 2
0.95 hrs
Inspect and remove PAS pump/pulley assembly and replace with new pump/pulley assembly QVB000040K
Normal warranty policy and procedures apply
REPAIR PROCEDURE
INSPECT PAS PUMP PULLEY