Range Rover (LP) V8-4.0L (1999)
/v8-4.0l/Page-1026008.png)
^
Switch off engine.
WARNING:
Fluid drained from the sump pan may be "hot." Exercise care when draining the fluid.
7.
Check the water content of the transmission fluid again as described in "Position Breather Tube and Test Fluid for Contamination."
8.
If the fluid is still contaminated go to Step 1 of this section and flush as many times as required until the fluid is clear.
9.
When the fluid checked is clear, perform the following:
^
Drain the fluid from the transmission.
^
Remove the sump pan and discard the pan seal.
^
Remove the strainer and discard.
^
Wipe out the sump pan with a lint free cloth to remove any residual debris and sludge.
^
Fit new strainer with O-ring and tighten retaining screws to 8 Nm (71 lbf.in.).
^
Install new sump pan seal.
^
Install the pan to the transmission and tighten fasteners to 8 Nm (71 lbf.in.).
10.
Fill the transmission with the correct quantity of fluid up to the level plug.
11.
Start and run the engine.
12.
Check fluid level as described in TIB 44/01/99/NAS to obtain proper fluid level.
13.
Road test the vehicle to verify that the transmission functions correctly.
14.
Install the campaign label as outlined in the "Campaign Label Installation" section and claim Recall Option 4.
CAMPAIGN LABEL INSTALLATION
NOTE:
Campaign labels may have multiple campaign numbers written on them if multiple campaigns are performed at the same time.
1.
When all specified repairs have been accomplished, prepare the campaign label (LRN0002LABEL) as follows:
a)
Place the label on a hard surface.
b)
Use a ballpoint pen to neatly write/scribe in the bare aluminum areas of the label the following information:
