Range Rover (LP) V8-4.0L (1999)
/v8-4.0l/Page-1029004.png)
8.
On Range Rover vehicles slide the white tube clip toward the rear of the vehicle until it stops against the bulge at the end of the repositioned drain
tube. (Figure 2)
9.
On Discovery Series II vehicles perform the following:
^
Snip the cable tie to release the breather tube from the electrical harness.
^
Slide the white tube clip toward the rear of the vehicle until resistance is met because of the divergence of the transmission and transfer box
tubes. (Figure 3)
^
Verify that the end of the breather tube is parallel with the AT breather and pointed toward the LH rear of the vehicle.
10.
Wipe any residual silicon lubricant from tubes.
11.
Go to "Campaign Label Installation" and install a label for D233
12.
Claim Recall D233 Option 2
PERFORM PARK LOCK TEST
CAUTION:
Every test must be carried out on a slope selected so that the vehicle will roll slowly forward with the transmission selector in the "N" neutral
position. Ensure that no obstruction or object will interfere with testing.
1.
Check the park lock function as follows:
^
Position vehicle on a slight forward down slope.
^
Start the engine, place the transmission in "N" neutral and allow the vehicle to roll forward no more than two meters (6 feet).
^
Stop the vehicle completely using the foot brake and select "P" park.
