Range Rover (LP) V8-4.0L (1999)
/v8-4.0l/Page-1055004.png)
23. Disconnect harness from gear selector switch multiplug and release multiplug from bracket.
24. Remove nut securing selector shaft lever and release lever from shaft.
25. Remove bolt and nut securing gear selector switch to gearbox and remove switch.
26. Drift out and discard selector quadrant roll pin. Remove selector shaft.
27. Remove selector quadrant and connecting rod.
28. Remove oil seal taking care not to damage seal housing.
Refit
29. Clean shaft and seal housing.
30. Using a suitable adapter, fit new seal.
31. Fit selector quadrant and connecting rod.
32. Fit selector shaft and secure to quadrant using new roll pin.
33. Fit valve block.
34. Position selector switch and tighten nut and bolt.
35. Position selector shaft lever and tighten nut.
36. Fit selector switch multiplug to bracket and connect harness to multiplug.
37. Align harness support bracket and gear selector cable abutment bracket to gearbox and secure with bolts.
38. Connect gear selector cable bunion to lever and fit split pin.
39. Adjust gear selector cable.
40. Raise gearbox on transmission jack.
41. Fit handbrake cable through transmission tunnel.
42. Clean propeller shaft and transfer box flanges.
43. Fit shafts to transfer box flanges, align marks and tighten nuts and bolts to 48 Nm (35 ft. lbs.).
44. Fit rear propeller shaft guard and secure with bolts.
45. Fit transmission mounting assembly and tighten bolts to 44 Nm (33 ft. lbs.).
46. Diesel models: Fit chassis crossmember.
47. Petrol models: Fit exhaust front pipe.
48. Connect handbrake cable to lever and fit clevis pin and clip.
49. Fit window switch pack.
50. Petrol models: Fit engine RH lifting eye, align earth strap and secure with bolts.
51. Petrol models: Fit cooling fan cowl and secure with clips.
