Range Rover (LP) V8-4.6L (2001)
20. Fit front cover to cylinder block and tighten bolts in sequence shown to 22 Nm (16 ft. lbs.). Ensure CMP sensor multiplug bracket is secured by
bolt.
21. Fit new 'O' rings to oil cooler pipes, connect pipes to front cover and tighten unions to 15 Nm (11 ft. lbs.).
22. Fit bolt securing oil cooler return pipe to alternator mounting bracket.
23. Connect Lucar to oil pressure switch.
24. Connect multiplug to CMP sensor.
25. Ensure oil filter seal and mating face on front cover is clean.
26. Lubricate seal with clean engine oil and fit engine oil filter.
27. Fit radiator cowl and secure with clips.
28. Fit oil cooler pipes into recesses in radiator cowl and tighten pipe unions to 30 Nm (22 ft. lbs.).
29. Fit thermostat housing to radiator cowl.
30. Connect bottom coolant hose to radiator and secure with clip.
31. Connect hose to water pump and secure with clip.
32. Connect top hose to radiator and secure with clip.
33. Ensure mating faces of water pump pulley and drive flange are clean, fit pulley and tighten bolts to 22 Nm (16 ft. lbs.).
34. Fit auxiliary belt jockey pulley and tighten bolt to 50 Nm (37 ft. lbs.).
35. Fit front cover oil seal.
36. Fit oil pick-up strainer.
37. Refill cooling system.