Range Rover County LWB (LH) V8-4.2L (1993)
Symbols
Terminal Number - Designation
50
-
Battery voltage: Ignition Switch in position III
30
-
Battery voltage: supplied constantly
15
-
Battery voltage: Ignition Switch in position II or III
R
-
Battery voltage: Ignition Switch in positions I, II
31
-
Ground
X
-
Switched battery voltage through the ignition load relay; ignition switch is in position II or III
49
-
Flasher unit input
49a -
Flasher unit output
56a -
High beam
56b -
Low beam
85
-
End of relay coil
86
-
Start of relay coil
87
-
Relay contact
87a -
Relay contact
Vehicle Component Codes
All components are identified by a letter followed by an arbitrary number assigned to the component. The letter assigned to the component indicates the
type of component.
B....................................................................................................................................................................Bulbs, Heated Screens, and Heated Washer Jets
K........................................................................................................................................................................... Relays, Solenoids, Speakers, and Resistors
M.................................................................................................................................................................................................................................. Motors
P................................................................................................................................................................................................ Fuse Boxes and Fusible Links
X............................................................................................................................................................................................................ Switches and Sensors
Z............................................................................................................................................................... Electronic Control Units, Modules, and Capacitors
Connectors, Grounds, and Splices are identified by a letter followed by a number. Connectors are identified by C, grounds by E, and splices by S. Some
splices are contained in junction connectors. These splices are identified by the prefix "HJ" below the splice's reference number. The number assigned to
the connector, ground or splice corresponds to its location in the vehicle.
Electrical Specific Information
Definition of Vehicle Component Codes
All components are identified by a letter followed by an arbitrary number assigned to the component. The letter assigned to the component indicates the
type of component.
B
Bulbs, Heated Screens, Mirror Demisters, Cigar Lighters, and Heated Washer Jets
K
Relays, Solenoids, Speakers, and Resistors
M
Motors
P
Fuse Boxes and Fusible Links
X
Switches and Sensors