landrover Workshop Repair Guides

Land Rover Workshop Service and Repair Manuals

Ignition Switch - Does Not Return To Run Position|Page 7864 > < Wheel Speed Sensor|Page 7852
Page 1
background image

Technical Service Bulletin # TEC8613971

Date: 970620

Ignition Switch - Does Not Return To Run Position

No: 86/13/97/NAS

Ref: WSM section 86

Issue: 1

Date: 06/20/97

PRIDE IV

5-07

Intermittent Electrical Circuit Operation at Start-up

AFFECTED VEHICLE RANGE:
RANGE ROVER (LP)

Up to VA370912 (Early-design column)
From VA370913 (Late-design column)

SITUATION:

IGNITION SWITCH DOES NOT RETURN TO RUN POSITION

On some Range Rovers, the friction in the ignition lock mechanism can prevent the key from returning to position "II" (run) when released from position
III (crank). When this occurs, the circuits that are normally disabled during cranking (for example the audio circuit or HVAC) may remain inoperative.

RESOLUTION:

REPLACE IGNITION SWITCH AND LUBRICATE IGNITION CYLINDER

NOTE:

Late-design columns must be replaced as an assembly. Because replacement columns may be of the later design it is important to verify the column
in the vehicle. See below for specific information to determine whether a vehicle has an early or late style column.

An ignition switch with higher return torque is now available for ignition switch replacement. As part of the replacement procedure the ignition lock
cylinder must be lubricated to facilitate return.

PARTS INFORMATION:

NOTE:

Late-design steering columns may not be repaired. They must be replaced if a mechanical fault occurs. See the column identification section for
details. Replacement columns ordered through parts will supersede to the later design.

STC2958A

Ignition Switch, High Torque

STC3219

Screws

Qty 2

STC2826

Grease

2 gm tube

ANR6313

Late-design steering column

(Repair not permitted)

WARRANTY CLAIMS:

86.65.02

Time 0.85 hrs.
Replace Ignition Switch

57.40.01

Time 1.45 hrs.
Replace steering column

COMP CODE:

7B4Y

Normal warranty policy and procedures apply

Repair Procedure

COLUMN IDENTIFICATION

NOTE:

Vehicles equipped with the late-design column (ANR6313) must use ANR6313 for repair. A vehicle equipped with the early-design column

Ignition Switch - Does Not Return To Run Position|Page 7864 > < Wheel Speed Sensor|Page 7852