Range Rover HSE (LP) V8-4.6L (1997)
/v8-4.6l/Page-1774002.png)
^
The screws are non replacable and other fasteners must not be used.
^
If the screws are damaged during removal, the steering wheel must be renewed.
3. Lift 2 clips (9) securing each switch pack.
-
Remove switch packs and printed circuit assembly.
ASSEMBLY
1. Position switch pack assembly.
-
Engage switches to steering wheel.
NOTE: Ensure switches are correctly engaged.
2. Secure multiplug and printed circuit with screws (8).
INSTALLATION
1. Route harnesses through steering wheel aperture.
2. Position steering wheel.
-
Secure with bolt (5), then tighten to 33 Nm (24 ft. lbs.).
3. Connect steering wheel switch multiplug.
4. Secure harnesses in clip (4).
5. Install drivers air bag module.
