landrover Workshop Repair Guides

Land Rover Workshop Service and Repair Manuals

Door - Clicking Noise When Opening/Closing|Page 15627 > < Door - Clicking Noise When Opening/Closing|Page 15625
Page 2
background image

Normal warranty policy and procedures apply.

COMP. CODE
9F7G

SRO
76.40.89131 - Tighten all check strap bolts - 00.20 hr.

Technical Service Bulletin # TEC763995

Date: 951117

Door - Clicking Noise When Opening/Closing

17/11/95

76/39/951US

SUBJECT
Clicking Noise on Door Opening/Closing

MODEL
Range Rover 4.0/4.6

AFFECTED VEHICLES 

LP 3O0190 to 325560 
LH 
LJ 
LD

DETAIL

A clicking noise when opening and closing any of the doors can be caused by a low torque of the check strap securing bolts. All vehicles within the
above VIN range that have not been checked at the Ports should have these bolts tightened to the correct torque.

The vehicles that the Ports have checked will have a white paint mark on the top bolt of the drivers door check strap. This will indicate that all bolts have
been checked, and no further action is required. If there is no mark then carry out the procedure below.

ACTION REQUIRED

Upon customer complaint, at PD or on the next service visit, tighten the check strap bolts to the correct torque.

PARTS INFORMATION

Not applicable

PROCEDURE

1.

Check for the presence of a white paint mark on the head of the top bolt, on the drivers door check strap. If a mark is visible no further action is

Door - Clicking Noise When Opening/Closing|Page 15627 > < Door - Clicking Noise When Opening/Closing|Page 15625