Range Rover SE (LP) V8-4.0L (1995)
/v8-4.0l/Page-2592013.png)
12.
Disconnect green clip. for exterior handle to latch link-Drivers door only.
12a. Remove exterior handle screw using a screwdriver and TX25 bit.
12b. Slide handle forward and remove.
12c. Lever grey clip off the link rod (latch to door lock barrel).
12d. Remove the exterior door handle and replace the dark grey clip (P/N MTC 9290)
13.
Remove 3-off latch screws using screwdriver and TX25 bit.
14.
Lower latch and remove from door.
List of Electrical Checks to Do When Door Latch Replaced
Front driver door.
The following checks need to be carried out if front drivers door latch is replaced.
1.
The Door Ajar Switch operation test.
2.
CDL switch operation test.
3.
CDL Motor operation test.
4.
Superlock Motor operation test.
5.
The Key IN switch operation test.
Front Passenger Door
The following checks need to be carried out if front passenger door latch is replaced.
1.
The Door Ajar Switch operation test.
2.
CDL switch operation test.
3.
CDL Motor operation test.
4.
Superlock Motor operation test
Rear Door.
The following checks need to be carried out if rear door latch is replaced.
1.
The Door Ajar Switch operation test.
3.
CDL Motor operation test.
4.
Superlock Motor operation test.
6.
Window operation and window setting operation.
1.
The Door Ajar Switch operation test.
Check with engine running that opening the door gives the Door open message for that door, if message is present then the door Ajar switch operation is
correct.
2.
CDL switch operation test
