Range Rover SE (LP) V8-4.0L (1995)
^
08578 - (3M) Strip Caulk
PROCEDURE
Perform the diagnostic procedures and repairs outlined for the repair of Rear Door Handle Loads.
WARRANTY:
Normal warranty procedures and policies apply.
COMP. CODE:
SRO:
76.37.89/27 - Time 0.9 hr.
Replace 1 latch and handle
76.37.89/28 - Time: 1.6 hrs.
Replace both latches and handles
DISASSEMBLY
1.
Remove the outside door handle to determine if the latest latch is fitted.
^
Remove the Torx(R) screw securing the rear of the handle.
^
Slide the handle forward to release it from the door and pivot the rear end outward to expose the linkage.
2.
If the handle is connected to the latch with a white plastic link, the latest parts are fitted. Reassemble and take no further action (figure 1).
3.
If the handle has a black lever, remove and discard it. The handle can be removed by pivoting it outward until it can be freed from the front
mounting point (figure 1).
4.
Remove the door casing.
^
Remove the inside release handle escutcheon (1 screw).
^
Remove the 2 screws securing the pull handle.
^
Using a door panel fork, gently release the 11 fir tree clips.
^
Disconnect the upper door speaker connector.
Note:
Some fir tree clips may pull off the door casing and remain in the door. Remove these clips from the door and reattach to the door casing. Replace