Range Rover SE (LP) V8-4.0L (1995)
/v8-4.0l/Page-2615009.png)
8.
Remove the window lift panel.
^
Remove the 3 door latch screws.
^
Remove the 2 glass channel spring clips (figure 2). while supporting the glass, free the lifter arms from the glass channel slides by prying
gently with a screwdriver.
^
Slide the window closed and secure into position using tape.
^
Drill out and remove the 4 rivets securing the window lift panel to the door.
^
Remove the window lift panel and door latch as an assembly.
9.
Remove the door latch from the window lift panel.
^
Disconnect the interior release cable from the latch.
^
Remove the 2 plastic rivets securing latch to the window lift panel.
^
Maneuver the latch off the sill button linkage.
REASSEMBLY
1.
Install latch on the window lift panel.
^
Maneuver latch onto sill button linkage.
^
Attach latch onto window lift panel using 2 plastic rivets (STC2756).
^
Attach interior release handle cable.
2.
Install the window lift panel.
^
Place the window lift panel into position in the door and attach using 4 metal rivets (RA612157L).
^
Slide window down and snap lifter arms into glass channel slides.
^
Replace the glass channel spring clips.
^
Install the 3 latch screws.
3.
Connect the window switch, window motor, and door latch.
4.
Snap 5 harness clips into the window lift panel.
5.
Install the outside door handle:
^
Slip the handle into the front mounting hole on the door and pivot the rear end inward.
^
Pull the white latch link out of the opening and snap the link onto the handle (figure 1).
^
Place the handle into position on the door and slide rearward to align bolt hole: install bolt
6.
Test the operation of the following:
^
Power window
^
Latch
^
Interior and exterior releases
^
Sill button, both manually and with central locking
^
Child lock
7.
Affix the water curtain to the door, sealing it carefully along the adhesive edges. Use strip caulk if additional adhesive is required.
8.
Install the amplifier.
9.
Install the lower door speaker.
11.
Connect the upper door speaker.
12.
Slip the sill button into door casing and align the 11 fir tree clips with their sockets. Tap casing into place.
13.
Install the 2 pull handle screws.
14.
Install the inside release handle escutcheon.
