Range Rover SE (LP) V8-4.0L (1995)
10.
Lower window to allow access to the butterfly clips.
11.
Remove clips off ball studs.
12.
Pull window -X- from channel and push glass back up.
13.
Disconnect latch.
14.
Disconnect regulator.
15.
Cut off 6 grey harness clips and discard. Clip (P/N YQR 10075).
16.
Pull window lift switch forward to remove from handle casing, Do not disconnect.
17.
Remove latch screws using a screwdriver and TX25 bit.
18.
Drill out rivets (4 off) in brose plate - ensure correct rivets are drilled using a 5 mm drill.
19.
Lift out plate assembly.
Note:
Fit new cable clips for harness (P/N YQR 10057).
Take care not to break off child lock button on reassembly.
When the door has been reassembled, operate exterior handle 3 to 4 times. Remove the rubber plug in the edge of the door by latch, insert a 3 mm Allen
key and secure the pre-load screw finger tight refit plug. where the Workshop Manual, in section 86 page 32 item NO 11 states 4 bolts, they are actually
pop rivets.
Refer to previous section for electrical checks for rear door.