Range Rover SE (LP) V8-4.0L (1995)
/v8-4.0l/Page-696004.png)
2.
Install gasket in valve cover recess, paying attention to the fit of the gasket onto the valve cover.
3.
Install valve cover onto cylinder head with four new bolts.
NOTE:
New style bolts must be used. These bolts have an integral acrylic seal under the head.
4.
Tighten the bolts in the sequence shown (figure 2) in two stages.
^
Stage one: 4 Nm. (3 lbf.ft.).
^
Stage two: 9 Nm. (7 lbf.ft.).
5.
Position fuel pipes.
6.
Install breather hose on valve cover, tighten clamp.
7.
Install coolant hoses to intake manifold, tighten bolts.
8.
Install spark plug wires to spark plugs and retaining clips.
9.
Connect purge pipe from charcoal canister at plenum, tighten clamp.
Plenum Chamber Installation
1.
Clean all mating surfaces.
2.
Position plenum chamber. Connect coolant hoses to water jacket, tighten clamps.
3.
Remove clamp from coolant hoses.
4.
Apply a thin, uniform coating of Loctite(R) # 577 sealant to mating surface of plenum chamber.
5.
Install plenum chamber.
6.
Install plenum chamber bolts. Tighten to 24 Nm. (18 lbf.ft.).
7.
Connect multi-plugs to throttle potentiometer and stepper motor.
8.
Connect breather hose to plenum chamber.
9.
Install throttle cable and cruise control cable onto bracket. Secure cruise control cable with "C" clip.
10.
Align cables with throttle linkage. Install clevis pins. Secure clevis pins with cotter pins.
11.
Adjust throttle cable if necessary.
12.
Connect intake hose and tighten clamp.
13.
Fasten heater hose with clip on intake manifold.
