Range Rover SE (LP) V8-4.0L (1995)
5.
Remove the three 5mm Allen bolts securing column tilt lever assembly to column. (Figure 2, Ref. 3)
6.
Remove lever and plastic release plunger from column. (Figure 2, Ref. 4)
7.
Disconnect and unclip ignition switch leads.
8.
Remove two screws securing switch to column. (Figure 2, Ref. 7)
9.
Remove switch
SWITCH INSTALLATION AND CYLINDER LUBRICATION
Switch Installation
1.
Position ignition switch on steering column.
2.
Apply threadlocker and install two screws securing the switch to the column.
Ignition lock cylinder removal, lubrication. and installation
1.
Turn key to position "II".
2.
Locate the 3 mm (1/8 in.) diameter hole on the rear facing surface of the cylinder housing.
3.
Using a slim punch or awl, depress the cylinder retainer inside the 3 mm (1/8 in.) hole to release the cylinder and pull the cylinder from the
column.
4.
Refer to Figure 3 and lubricate the cylinder back plate and ramp with STC2826.
5.
Install the lubricated cylinder ensuring that the retainer engages the 3 mm (1/8 in.) hole upon installation.
Assembly
1.
Connect and clip ignition switch leads.
2.
Install plastic release plunger in column and fit steering column tilt lever assembly.
3.
Install steering column shroud.