Range Rover SE (LP) V8-4.0L (1995)
/v8-4.0l/Page-1746002.png)
1.
Remove four nuts and bolts securing driveshaft to differential.
2.
Release shaft and tie aside (figure 1).
3.
Hold differential flange with tool # LRT-51-003 (figure 2).
4.
Remove flange nut.
5.
Remove flange.
6.
Remove oil seal with a suitable tool.
Inspection
1.
Inspect seal locating bore and remove any sharp edges that may damage new oil seal.
2.
Inspect front and rear transfer box output seals for leakage. Replace transfer box seals if leakage is present.
3.
Check breather for proper operation.
Installation
1.
Ensure that all mating surfaces are clean.
2.
Lubricate oil seal with axle oil.
3.
Using tool # LRT-51-009, install seal in differential.
4.
Install flange as follows:
^
Position flange.
^
Hold flange with tool LRT-51-003 (figure 2).
