Range Rover SE (LP) V8-4.0L (1995)
/v8-4.0l/Page-1751005.png)
5.
Remove flange.
6.
Remove oil seal with a suitable tool.
Inspection
1.
Inspect seal locating bore and remove any sharp edges that may damage new oil seal.
2.
Inspect front and rear transfer box output seals for leakage. Replace transfer box seals if leakage is present.
3.
Check breather for proper operation.
Installation
1.
Ensure that all mating surfaces are clean.
2.
Lubricate oil seal with axle oil.
3.
Using tool # LRT-51-009, install seal in differential.
4.
Install flange as follows:
^
Position flange.
^
Hold flange with tool LRT-51-003 (figure 2).
^
Install new nut and tighten to 135 Nm (100 lbf. ft.).
5.
Using a dial indicator check the drive flange.
Maximum permissible run out
0.010 mm (0.004 inches)
Face run out
0.010 mm (0.004 inches)
NOTE:
Run out and face run out may be optimized by removing the drive flange and rotating it through 180 degrees prior to refitting.
6.
Reinstall driveshaft with bolts and new nuts. Tighten to 48 Nm. (35 lbf. ft.).
7.
Replenish axle oil (GL4, GL5).
8.
Mark nose of differentials with marker supplied.
9.
Road test vehicle and check for leaks.
WARRANTY:
Normal warranty procedures and policies apply.
COMP.CODE:
4S1N
4S5N
SRO:
51.20.01 - Time: 0.55 hr.
Rear Pinion Seal Replacement
54.10.20 - Time: 0.55 hr.
Front Pinion Seal Replacement
Technical Service Bulletin # TEC510596
Date: 961231
