Range Rover Sport (LS) V8-4.2L SC (2006)
/v8-4.2l_sc/Page-3045005.png)
With assistance, install the hood latch panel.
6. Install the panel fixings.
^
Install and tighten the bolts to 25 Nm (18 ft. lbs.).
^
Install the hood seal.
7. Install the wiring harness.
^
Secure the 6 clips.
^
Connect and secure the electrical connector.
8. Install the speed control sensor.
^
Evenly and progressively tighten the bolts to 10 Nm (7 ft. lbs.).
^
Connect and secure the electrical connector.
9. Install the bumper support bracket.
^
Tighten the screws.
^
Repeat the above procedure for the other side.
10. Install the hood release cable.
^
Secure in the 3 clips.
11. Install the radiator securing pegs.
12. Install the coolant expansion tank.
^
Position the coolant expansion tank, locate the spigot and lug.
^
Install the bolts and tighten to 10 Nm (7 ft. lbs.).
13. Install the windshield washer reservoir filler neck.
^
Locate in clip.
14. Install the power steering fluid reservoir.
^
Position and secure to mounting bracket.
15. Install the front bumper cover.
16. Open and close the hood to check the hood latch operation.
17. Adjust both of the hood latches.
^
Loosen the 4 hood latch Torx bolts.
^
Lower the hood and check for alignment.
^
Open the hood and tighten the Torx bolts to 10 Nm (7 ft. lbs.).
^
Check for the correct operation of the hood safety catch.
^
If necessary, repeat the above adjustment procedure.
18. Connect the battery ground cable.
