Range Rover Sport (LS) V8-4.2L SC (2006)
/v8-4.2l_sc/Page-845002.png)
^
Clamp the relevant hoses, to minimize the coolant loss.
^
Release the 2 clips.
Installation
1. Connect the coolant hoses.
^
Clean the component mating faces.
^
Secure the clips.
^
Remove the hose clamps.
2. Install the oil cooler.
^
Clean the component mating faces.
^
Install the 4 bolts and tighten to 10 Nm (7 ft. lbs.).
^
Connect the hoses.
3. Install the oil cooler pipe support bracket.
^
Tighten the bolt to 10 Nm (7 ft. lbs.).
4. Install the radiator access panel.
^
Tighten the bolts to 10 Nm (7 ft. lbs.).
5. Install the engine undershield.
6. Check and top-up the engine oil.
7. Connect the battery ground cable.
8. Check and top-up the coolant.
