Range Rover Sport (LS) V8-4.2L SC (2006)
INSTALL REAR STABILIZER BAR BUSHING PACKERS
NOTE:
Global Technical Reference (GTR) lookup sequence is as follows: GTR Home > NAS > Model > Service Information > Model Year > Workshop
Manuals
1. *Inspect the rear stabilizer bar bushings for:
^ Free play by attempting to move the stabilizer bar within the bushing by hand.
^ Cracks or splits
^ 'Old' or ' New ' style ('A' or 'B', Figure 1)
2. If any free play, cracks, or splits are found in the stabilizer bar bushings, refer to Workshop Manual (GTR) Section 204-02 to replace the rear
stabilizer bar bushings; do not install stabilizer bar packers. To be carried out as a separate claim.
3. If 'New' style stabilizer bar bushings are fitted, do not install stabilizer bar packers. Diagnose as a separate claim.
4. If no free play, cracks, or splits are found in the stabilizer bar bushings, refer to Workshop Manual (GTR) Section 100-02 to raise and support the
vehicle.*
5. Loosen (do not remove) the two nuts on left and right-hand rear stabilizer bar bushing brackets.
6. Reposition stabilizer bar bushing / brackets to allow sufficient clearance between bushing and chassis. (Figure 2)
7. Install bushing packer between left and right-hand bushing and chassis. (Figure 2)
CAUTION:
Ensure the bushing packer is not trapped between the stabilizer bar bushing bracket and chassis.
8. Tighten the two nuts on the left and right-hand stabilizer bar bushing brackets to 62 Nm (46 lbf ft).
INSTALL FRONT STABILIZER BAR BUSHING PACKERS
NOTE:
Global Technical Reference (GTR) lookup sequence is as follows: GTR Home > NAS > Model > Service Information > Model Year > Workshop