Range Rover Sport (LS) V8-4.2L SC (2006)
/v8-4.2l_sc/Page-1168001.png)
Camshaft Position Sensor: Service and Repair
Camshaft Position (CMP) Sensor
Service Repair No - 18.30.24
Removal
1. Disconnect the battery ground cable.
2. Remove the throttle body gasket.
3. Remove the camshaft position (CMP) sensor.
^
Disconnect the electrical connector.
^
Remove the Torx screw.
^
Discard the O-ring seal.
NOTE: Removal of the RH sensor is similar to this procedure.
Installation
1. To install, reverse the removal procedure.
^
Clean the component mating faces.
^
Install a new O-ring seal.
^
Tighten the Torx screw to 7 Nm (5 ft. lbs.).
