Range Rover Sport (LS) V8-4.2L SC (2006)
2.
Logon to GTR from an internet connected PC and download the WDS software patch installation help file as follows:
^
Select "Home" from the menu at the top of the main page.
^
From the menus on the left of the page, select "Diagnostics" as the "Information Type" and select the relevant model and model year.
^
From the "All Information" results, select "Patch Files".
Click the file link "Patch Process Help File".
NOTE:
This could take up to twenty minutes to download dependent on connection speed.
3.
Using the help file as a guide, follow the instructions to download and save WDS CD13 - Patch File
4.
Install the software patch file "WDS CD13 - Patch File 3" into 14/ WDS and verify that WDS successfully restarts.
NOTE:
Midronics battery charger PSC550 must be connected to the vehicle battery during diagnosis/module configuration.
5.
Connect the diagnostic equipment to the vehicle and begin a WDS or IDS session.
6.
Note the current software levels of the engine control module as follows:
^
Enter the vehicle details.
^
Select the "Vehicle Configuration" tab.
^
Select "Module Information"
^
Select "Network integrity test"
Note the software part numbers displayed on the screen.
NOTE:
During module configuration, the on-screen software part number information that WDS/IDS will display can be checked and compared to the
software part number noted in step 4 above. If the same tune level is displayed, the vehicle already has the desired software level and the tune
download process can be aborted.
7.
Configure the control module:
^
Return to the "Vehicle Configuration" screen and select "Module Configuration"
^
Select "Configure Existing Modules".
^
From the sub-menu, select "Engine Control Module"
^
Check the tick-box to continue and follow the on-screen instructions.
^
Compare the on-screen software part number information that WDS/IDS will display with the software part number noted in step 4 above.
If the same tune level is displayed, terminate the tune download.
NOTE:
Software levels should be as listed below, or later:
^
Normally Aspirated:
NNV502048
^
Supercharged:
NNV504380
8.
Repeat step 6 to confirm the software level change.
9.
Exit the WDS session and disconnect the diagnostic equipment from the vehicle.