Range Rover Sport (LS) V8-4.2L SC (2006)
/v8-4.2l_sc/Page-202001.png)
Distance Sensor: Service and Repair
Speed Control Sensor
Removal
1. Disconnect the battery ground cable.
2. Remove the front bumper cover.
3. Remove the LH bumper support bracket.
^
Remove the 3 Torx screws.
^
Remove the screw.
4. Remove the speed control sensor.
^
Remove the 2 bolts.
^
Remove the nut.
^
Release and disconnect the electrical connector.
Installation
1. Install the speed control sensor.
^
Tighten the nuts and bolts to 10 Nm (7 ft. lbs.).
^
Connect and secure the electrical connector.
2. Install the bumper support bracket.
^
Tighten the screws.
3. Connect the battery ground cable.
4. Adjust the speed control sensor.
5. Install the front bumper cover.
6. Using T4, configure a new speed control sensor.
