landrover Workshop Repair Guides

Land Rover Workshop Service and Repair Manuals

Customer Interest for Suspension Control Pressure Sensor/Switch: > < Suspension - Warning Lamp ON/Multiple Codes Set|Page 9644
Page 17
background image

^

The route traveled should ensure that the dynamic response system is activated.

22.

If the pump or an actuator has been replaced, perform a 10 mile road test on twisty roads to exercise the system.

23.

When the test drive is complete use IDS to verify that no DTCs appear.

24.

Refer to GTR Workshop Manual, section 204-06 (60.60.21) to install a new valve block filter.

25.

Start the engine and allow to run for a short period.

26.

Check and top-up the dynamic response system fluid reservoir to mid-way between the 'MAX' and 'MIN' marks.

Customer Interest for Suspension Control Pressure Sensor/Switch: > < Suspension - Warning Lamp ON/Multiple Codes Set|Page 9644