landrover Workshop Repair Guides

Land Rover Workshop Service and Repair Manuals

Steering - Squeaking Noise When Turning|Page 9723 > < Steering - Squeaking Noise When Turning|Page 9721
Page 3
background image

7.

Hold the funnel steady, and add the specified PS fluid until it fills the funnel approximately halfway.

WARNING:

Feet must be clear of wheels/tires during the following operation.

NOTE:

Be prepared to carry out the filling procedure with FOUR LITERS (FOUR QUARTS) of PAS fluid simultaneously as the engine start and
steering wheel movement is performed by the assistant.

CAUTION:

Do not allow the level in the reservoir to fall below the minimum mark at any time and ensure the engine is turned off just as the full amount of
fluid has entered the reservoir, to avoid running the system dry.

8.

Perform the following two steps simultaneously:

^

Have an assistant start the engine.

^

Immediately upon engine start-up begin filling the funnel/reservoir with PAS fluid ensuring that the mid-point level is maintained in the funnel.
(Figure 4)

9.

Have the assistant turn the steering wheel slowly from lock to lock three times over approximately 30 seconds.

10.

Continue to pour until the four liters (4 quarts) of fluid has been added (approximately 30 seconds).

Steering - Squeaking Noise When Turning|Page 9723 > < Steering - Squeaking Noise When Turning|Page 9721