Range Rover Sport (LS) V8-4.2L SC (2006)
Suspension Control Pressure Sensor/Switch: Service and Repair
Vehicle Dynamic Suspension
Air Suspension Pressure Sensor
Removal
1. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
2. Remove the air compressor housing cover.
^
Remove the 3 bolts.
^
Release the 5 clips.
3. Using T4, depressurize the air suspension.
4. NOTE: Disconnect the electrical connector.
Make sure the valve block does not become detached during removal of the air pressure sensor.
5. CAUTION: Before the disconnection or removal of any components, ensure the area around joint faces and connections are clean. Plug any open
connections to prevent contamination.
Remove the air pressure sensor.
^
Remove and discard the O-ring seal.
Installation
1. NOTE: Install the air pressure sensor.
Make sure the valve block does not become detached during installation of the air pressure sensor.
^
Install a new O-ring seal.
^
Tighten to 5 Nm (4 ft. lbs.).
2. Connect the electrical connector.
3. Using T4, pressurize the air suspension.
4. CAUTION: Make sure the air suspension compressor upper cover is correctly positioned.
CAUTION: Make sure the air suspension exhaust pipe is correctly located in to the air suspension upper cover.
Install the air compressor housing cover.
^
Install the bolts and tighten to 9 Nm (7 ft. lbs.).