Range Rover Sport (LS) V8-4.2L SC (2006)
9.
Connect the special tool (204-591-02) electrical connectors to the valve block. (Figure 12)
10.
Connect the special tool (204-591-02) power supply leads to the vehicle battery.
NOTE:
The O-ring seals are to be reused unless damaged.
11.
Flush the front set of pipes as follows:
^
Disconnect the dynamic response fluid pipes from the actuator.
^
Using the special tool, open both actuator control valves.
^
Flush fluid through the front pipes until approximately 0.5 liter has been displaced.
^
Connect the fluid lines to the actuator and tighten the two bolts to 22 Nm (16 lbf ft).
12.
Flush the rear set of pipes as follows: