Range Rover Sport (LS) V8-4.4L (2009)
/v8-4.4l/Page-2200002.png)
8. WARNING: Make sure the liftgate is supported.
With assistance, remove the liftgate glass.
^
Remove and discard the 2 nuts.
Installation
1. With assistance, install the liftgate glass.
^
Tighten the nuts to 25 Nm (18 ft. lbs.).
2. Install the liftgate glass support struts.
^
Secure the clips.
3. Install the liftgate wiring harness.
^
Connect and secure the electrical connectors.
^
Connect the washer jet hose.
^
Install the gaiter.
4. Install the headlining.
^
Install the clips.
^
Install the liftgate seal.
5. Install the rear window wiper motor.
6. Install the liftgate glass trim panel.
7. Install the spoiler.
8. Connect the battery ground cable.
9. Check the liftgate glass alignment and adjust if required.
