Range Rover Sport (LS) V8-4.4L (2009)
/v8-4.4l/Page-1438004.png)
7. Remove the brake disc.
^
Remove the Torx screw.
Installation
1. Make sure the brake disc and hub mating surfaces are clean.
2. Install the brake disc.
^
Tighten the Torx screw to 35 Nm (26 ft. lbs.).
3. Secure the brake caliper to the wheel knuckle.
^
Tighten the bolts to 275 Nm (203 ft. lbs.).
4. Secure the brake hose retaining bracket to the wheel knuckle.
^
Tighten the bolt to 23 Nm (17 ft. lbs.).
5. WARNING: Do not use compressed air to clean brake components. Dust from friction materials can be harmful if inhaled.
Clean the components.
6. Inspect the caliper piston seals for damage.
7. Position a bleed jar containing a small quantity of approved brake fluid. Connect the bleed tube to the bleed screw and loosen the screw.
8. Press the pistons into the caliper housing.
^
Tighten the bleed screw to 19 Nm (14 ft. lbs.).
9. Repeat the above process for the other 2 pistons.
10. Disconnect the bleed tube and remove the jar.
11. Install the brake pads.
^
Position the anti-rattle spring.
^
Install the pins, making sure the pin collets are fully engaged in the caliper.
12. LH side only: Connect the brake pad wear indicator sensor.
^
Secure the lead in the clips.
13. Install the wheel and tire.
^
Tighten the wheel nuts to 140 Nm (103 ft. lbs.).
14. Depress the brake pedal several times, check the fluid level in the brake fluid reservoir and top-up with brake fluid if necessary.
