Range Rover Sport (LS) V8-4.4L (2009)
/v8-4.4l/Page-1478003.png)
1. Install the brake booster.
^
Tighten the nuts to 23 Nm (17 ft. lbs.).
2. Install the brake master cylinder.
^
Tighten the nuts to 26 Nm (19 ft. lbs.).
3. Connect the brake booster vacuum hose.
All vehicles
4. Connect the low brake fluid warning indicator switch electrical connector.
5. Install the brake tubes.
^
Tighten the M12 brake pipe unions to 16 Nm (12 ft. lbs.).
^
Tighten the M14 brake pipe unions to 18 Nm (13 ft. lbs.).
6. Install the inner plenum base.
7. Install the brake booster push rod clevis pin.
^
Install a new retaining clip.
8. Install the brake pedal buffer.
^
Tighten the bolts to 10 Nm (7 ft. lbs.).
^
Secure the wiring harness clip.
9. Install the instrument panel access panel.
^
Secure the screws.
10. Bleed the brake system using T4.
11. Install the closing trim panel.
^
Connect the electrical connector.
^
Secure the clip.
^
Tighten the screws.
