Range Rover Sport (LS) V8-4.4L (2009)
^
Remove and discard the 0-ring seal.
64. Remove the oil pan extension.
^
Remove the 18 bolts.
65. Remove the oil pump assembly. Remove the 4 bolts.
^
Remove and discard the gasket.
^
Clean the component mating faces.
66. Remove the baffle plate.
^
Remove the 6 bolts.
CAUTION: To make sure damage does not occur to the crankshaft and piston components, the engine must be inverted on the engine stand.
Failure to follow this instruction may result in damage to the engine.
NOTE: If the crankshaft main bearing carrier retaining bolts have been marked with a center punch dot, they must be discarded and new bolts
installed.
67. Remove the crankshaft main bearing carrier.
^
Remove the crankshaft main bearing carrier retaining bolts in the indicated sequence.
68. Discard the crankshaft rear main oil seal.