Range Rover Sport (LS) V8-4.4L (2009)
Suspension Control Module: Service and Repair
Dynamic Response Module
Dynamic Response Module
Service Repair No - 60.60.01
Removal
NOTE: The dynamic response module is always located on the driver's side of the vehicle.
1. Remove the cowl side trim panel.
2. Remove the closing trim panel.
^
Release the clip.
^
Remove the 2 screws.
^
Disconnect the electrical connector.
3. Remove the dynamic response module.
^
Remove the 2 bolts.
^
Disconnect the 2 electrical connectors.
Installation
1. Install the dynamic response module.
^
Connect the electrical connectors.
^
Tighten the 2 bolts to 4 Nm (3 lb.ft).
2. Install the closing trim panel.
^
Connect the electrical connector.
^
Secure the clip.