Range Rover Sport (LS) V8-4.4L (2009)
Installation
1. Install the steering angle sensor.
^
Tighten the Torx screws to 3 Nm (2 lb.ft).
2. Connect the steering column intermediate shaft.
^
Install the special bolt and tighten the new nut to 22 Nm (16 lb.ft).
3. Connect the steering angle sensor electrical connector.
4. Install the closing trim panel.
^
Connect the electrical connector.
^
Secure the clip.
^
Tighten the screws.
5. Connect the battery ground cable.
6. Initiate a new steering angle sensor using T4.