Range Rover Sport (LS) V8-4.4L (2009)
/v8-4.4l/Page-1532003.png)
be rotated. Failure to comply will cause the incorrect operation of the lock, and the assembly must be replaced.
NOTE: Do not disassemble further if the component is removed for access only.
Remove the ignition lock cylinder.
^
Turn the ignition key to position 1.
^
Insert a pin, not exceeding 2 mm diameter, through the access hole in the ignition lock cylinder housing to depress the plunger, and release the
ignition lock cylinder.
12. Remove the ignition switch.
^
Depress the 2 clips.
Installation
1. Install the ignition switch.
^
Secure with the clips.
2. Install the ignition lock cylinder.
^
Turn the ignition key to position 1.
^
Locate into guides and depress the plunger.
3. Install the passive coil.
^
Secure the clips.
^
Connect the electrical connector.
4. Install the ignition switch assembly.
^
Tighten the shear bolts until the heads shear off.
^
Connect the electrical connector.
5. Install the steering column switch assembly.
^
Tighten the Torx bolts to 3 Nm (2 lb.ft).
6. Connect the clockspring and multifunction switch electrical connectors.
