Range Rover Sport (LS) V8-4.4L (2009)
All vehicles
6. Remove the transmission support insulator through-bolt.
^
Support the transfer case.
7. Remove the crossmember.
^
Remove the 4 nuts and bolts.
Installation
All vehicles
1. Install the crossmember.
^
Tighten the nuts and bolts to 90 Nm (66 ft. lbs.).
2. Install the transmission support insulator through-bolt and tighten to 175 Nm (129 ft. lbs.).
Vehicles with petrol engine
3. CAUTION: Make sure the H02S wiring harness is not twisted more than 180 degrees and is not in contact with either the exhaust or
driveshaft.
Attach the HO2S wiring harness and bracket to the crossmember.
^
Tighten the bolts to 10 Nm (7 ft. lbs.).
Vehicles with diesel engine
4. Secure the 3 fuel lines.
^
Secure in the clips.
5. Connect the exhaust front mounting.
All vehicles