ES 300 V6-3.0L (1MZ-FE) (1997)
Refer to Figure 4.
A.
Align the new seat heater by placing the marked side (part number) against the seat cushion cover.
B.
For part A, position the seat heater by aligning the end of the fin with the fold line of the listing pocket.
C.
For part B, position the seat heater by aligning the heater's center line with the cover's V slit.
D.
Using a tacker, attach the seat heater to the seat cushion cover.
NOTE:
^
Do not substitute other metal parts in place of tack pins.
^
Insufficient distance between the heater and cover may result in damage to the heater.
HINT:
^
Attach tack pins on the seam side so that the wire can be passed through the hole from the fold side.
^
Sewing thread can be substituted for tack pins. However, allow a distance of 6-7 mm (0.24-0.28 in.) between both sewn parts of the heater and
cover.
5.
Seatback cover: Install new seat heater.