ES 300 V6-3.0L (3VZ-FE) (1992)
/Page-1204004.png)
3.
Remove Combination Meter Character Plate (Figure 8).
a)
Remove sixteen screws
b)
Gently remove the Combination Meter Character Plate from the Meter Case.
NOTE:
Do not bend, damage or mutilate the two Tachometer and/or two Speedometer electrical jumper pins when removing the Combination Meter
Character Plate from the Meter Case.
4.
Fuel Gauge removal (Figure 9).
a)
Remove the Fuel Gauge by sliding it away from the Character Plate.
5.
Fuel Gauge installation (Figure 10).
a)
Do not to disturb the position of the replacement Fuel Gauge Needle during the removal from the packaging and the installation.
b)
Slide the fuel gauge into position.
6.
Reassembly of the Combination Meter
a)
Follow steps 1 - 3 in reverse order.
Installation of Combination Meter
