ES 300 V6-3.0L (3VZ-FE) (1992)
Wire Holder
DISCONNECT HIGH-TENSION CORDS FROM DISTRIBUTOR CAP AND IGNITION COIL
(a)
Using a screwdriver, lift up the lock claw and disconnect the holder from the distributor cap (ignition coil).
Ignition Cord Removal And Installation
(b)
Disconnect the high-tension cord at the grommet. DO NOT pull on the cord.
NOTICE:
^
Pulling on or bending the cords may damage the conductor inside.
^
Do not wipe any of the oil from the grommet after the high-tension cord is disconnected.
DISCONNECT DISTRIBUTOR CONNECTOR
Distributor Hold-down Bolts
REMOVE DISTRIBUTOR
(a)
Remove the hold-down bolts and pull out the distributor.
(b)
Remove the O-ring from the distributor housing.