lexus Workshop Repair Guides

Lexus Workshop Service and Repair Manuals

Battery Maintenance for In-Stock Vehicles|Page 2424 > < Battery Maintenance for In-Stock Vehicles|Page 2422
Page 1
background image

Battery: Technical Service Bulletins
Battery Maintenance -  of In Stock Vehicles

ELECTRICAL
EL95-002
FEBRUARY 10, 1995
ALL MODELS

A battery in a stored vehicle is subject to conditions which can reduce its performance and life.

These conditions include storage period, temperature, parasitic drain, and battery load. Because of these factors, battery inspection and maintenance are
recommended in order to ensure proper operation and optimal battery life.

As a matter of policy, Lexus does not provide battery warranty coverage for excessively discharged and/or failed batteries due to lack of maintenance.
Consequently it is considered the dealers' responsibility to maintain the specified state of charge of the vehicle's battery while in stock.

BATTERY MAINTENANCE RECOMMENDATIONS:

1. A monthly battery inspection is recommended under normal conditions. If your dealership is located in an area subject to extreme temperatures (hot

or cold), periodic maintenance may need to be performed on a more frequent basis. When maintenance requires removal of filler plugs on vehicles
with "maintenance free" batteries, new labels are available via the illustrated part numbers.

2. To reduce battery drain during storage of in-stock vehicles, the dome light fuse of each vehicle should be removed. It is recommended that the fuse

remain disconnected until time of delivery. This procedure can reduce battery discharge 60-80 percent. Ideally, disconnecting the negative battery
cable from the battery, will further reduce battery discharge.

Note 1:

For your reference, the electrical systems made inoperative by removing the dome light fuse, are indicated in the appropriate Electrical Wiring
Diagram.

Note 2:

Additional battery maintenance information is available in the Lexus Warranty Reference And Administration Procedures Manual (policy # 4.10
pages 1-4).

Two test procedures are available for evaluating battery performance. These include:

1.

Open-Circuit Voltage Test Procedure

2.

Specific Gravity Test Procedure

OPEN-CIRCUIT VOLTAGE TEST PROCEDURE:

1.

If the battery has recently been charged or if the engine has been run in the last hour, there will be a surface charge on the battery. To remove the
surface charge, turn on the head lights for two minutes.

NOTE:

Turn oft headlights before proceeding with test.

Battery Maintenance for In-Stock Vehicles|Page 2424 > < Battery Maintenance for In-Stock Vehicles|Page 2422