ES 350 V6-3.5L (2GR-FE) (2007)
a. Disconnect the pad switch connector from the spiral cable.
b. Remove the 2 screws.
c. Disengage the 4 claws and remove the steering pad switch assembly.
INSTALLATION
1. INSTALL STEERING PAD SWITCH ASSEMBLY
a. Engage the 4 claws.
b. Install the steering pad switch assembly with the 2 screws.
Torque: 2.4 N.m (25 kgf.cm, 21 in.lbf)
c. Connect the connector to the spiral cable.
2. INSTALL STEERING PAD
3. INSTALL LOWER NO. 3 STEERING WHEEL COVER
4. INSTALL LOWER NO. 2 STEERING WHEEL COVER
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
6. PERFORM INITIALIZATION
NOTE: Some systems need initialization after reconnecting the cable to the negative battery terminal.
7. INSPECT SRS WARNING LIGHT