ES 350 V6-3.5L (2GR-FE) (2007)
A. Remove sliding roof side garnish.
(1) Fully open the No. 2 sliding roof sub-assembly.
(2) Using a T25 TORX driver remove the screw and sliding roof side garnish.
B. Remove No.2 sliding roof glass sub-assembly.
(1) Fully close the No.2 sliding roof glass sub-assembly.
(2) Using a T25 TORX driver remove the 3 screws.
(3) Remove the No.2 sliding roof glass sub-assembly.
C. Install New Felt Pads.
(1) Turn glass over and lay on soft cloth or protective blanket.
(2) Completely remove the 2 felt pads located on rear underside of the moonroof glass.
NOTE
Clean the panel after removing the 2 felt pads.