ES 350 V6-3.5L (2GR-FE) (2007)
6.
Install door frame garnish.
A.
Engage the clip and install the door frame garnish.
B.
Install the rear clip.
7.
Re-Install the front door handle cables trim board sub-assembly door armrest courtesy light arm rest base panel and connector and handle bezel
plug in reverse order of disassembly.
8.
Install front door belt molding assembly.
A.
Slide the front portion of the belt molding into the lower outside molding.
B.
Firmly press down on the molding and ensure all clips snap into position.
9.
Test drive the vehicle to confirm that the wind noise is reduced.