ES 350 V6-3.5L (2GR-FE) (2007)
(g) Tighten the tie rod end lock nuts.
Torque: 74 N*m (755 kgf*cm, 55 ft.*lbf)
NOTICE: Temporarily tighten the lock nut while holding the hexagonal part of the steering rack end so that the lock nut and the steering
rack end do not turn together. Hold the flats on the tie rod end and tighten the lock nut.
(h) Place the boots on the seats and install the clips.
HINT: Make sure that the boots are not twisted.
5. INSPECT WHEEL ANGLE
(a)
Put tread center marks on the rearmost points of the turning radius gauge.
(b) Turn the steering wheel fully to the left and right and measure the turning angle.
Wheel turning angle
If the right and left inside wheel angles differ from the specified value, check the right and left rack end lengths.
6. INSPECT CAMBER, CASTER AND STEERING AXIS INCLINATION
(a)
Put the front wheel on the center of the alignment tester.
(b) Remove the center ornament.
(c)
Set the camber-caster-king pin gauge and attachment at the center of the axle hub or drive shaft.
(d) Inspect the camber, caster, and steering axis inclination.
Camber